Five services on one OBi202 or how to split between two devices?

<< < (2/3) > >>

hwittenb:
Quote from: azrobert on June 17, 2013, 11:47:26 am

Can anyone verify if a VG will work with DNS SRV?

I can confirm that Anveo will work for unregistered outgoing calls using an OBi VoiceGateway.

As for the DNS SRV bit, I'm not sure where you specify or unspecify DNS SRV records.  I see there is a setting under the ITSP Profile for SIP to prepend service prefix to domain name when query by DNS SRV.  The default for this setting is unchecked (NO) which is what I have.  I ran a Wireshark packet trace on a test call and the OBI initially does three back to back DNS queries for sip.anveo.com, SRV sip.anveo.com and SRV _sip._udp.sip.anveo.com which is more or less covering the waterfront.  The standard query responds 72.9.149.69, the SRV query responds without an address, and the SRV _sip._udp.sip.anveo.com query responds with 72.9.149.69 for sip.anveo.com and 67.212.84.21 for sip.ca.anveo.com.

sir_rob:
Quote from: azrobert on June 17, 2013, 11:47:26 am

What are your requirements?

Are you only using CC for Cname?


My requirements are that I want Cname in, google voice out, and 911 service - all for both lines on one OBi202.

I am using CC for Cname and as a redirect.  If friends and family call GV #2 it forwards the call to both lines via the shared CC number (yes - both GV accounts have the CC number entered as a forwarding line).

Thanks!

azrobert:
Voice Services -> Gateways and Trunks Groups -> Voice Gateway 1
Name: Anveo 911
Access Number: sp4(sip.anveo.com)
DigitMap: (911|933)
AuthUserID: YourID
AuthPassword: YourPW

In your Phone Port Outbound Call Route you currently have something like:
{(911|933):sp4}

Change it to:
{(Mvg1):vg1}

This will free up SP4 for your 2nd Callcentric inbound number.

hwittenb,

Do I have the Access Number correct?

Thanks

giqcass:
Do a 911 test by dialing 933 after you made the changes.

hwittenb:
Quote from: azrobert on June 17, 2013, 04:32:31 pm

Access Number: sp4(sip.anveo.com)

hwittenb,
Do I have the Access Number correct?


For normal Anveo calling Anveo doesn't use the default port, but instead use port 5010.  I don't know if they do anything special for E911.  Assuming they do not do anything special the access number would be

Access Number: sp4(sip.anveo.com:5010)

Navigation

[0] Message Index

[#] Next page

[*] Previous page