Obi202 Calls work but dialpad doesn't! ???
WorkFromHomeMan:
Great! almost there, now it's asking for user/password and I typed admid/admin with no avail. is that the right default credentials?
WorkFromHomeMan:
..still stuck on the login part. It says admin@OBi202 in the login screen tooltip if that helps?? admin/admin is what the manual said which doesn't work. :-\
azrobert:
admin/admin is the factory settings, but you probably changed the password when you added your OBi to ObiTalk.
Log into OBiTalk.
On the Dashboard under "My OBi Endpoints" click on your device.
Webpage Admin Password is what you need.
azrobert:
You can try different DTMF methods.
Service Providers -> ITSP Profile A/B -> General -> DTMFMethod
Try RFC2833 first.
WorkFromHomeMan:
K Great I'm at the status screen during a call part..
Here's a sample
Number of Active Calls: 1
Call 1
Terminal 1 Terminal 2
Terminal ID PHONE1 GoogleVoice1
State connected connected
Peer Name
Peer Number 13122225080 13122225080
Start Time 10:33:11 10:33:11
Duration 00:00:01 00:00:04
Direction Outbound Outbound
Peer RTP Address 74.125.130.127:19305(relay)
Local RTP Address 192.168.1.132:6448
RTP Transport UDP
Audio Codec tx=G711U; rx=G711U
RTP Packetization (ms) tx=20; rx=20
RTP Packet Count tx=190; rx=95
RTP Byte Count tx=32680; rx=16340
Peer Clock Differential Rate 0 PPM
Packets In Jitter Buffer 5
Packets Out-Of-Order 0
Packets (10ms) Interpolated 0
Packets Late (Dropped) 0
Packets Lost 0
Packet Loss Rate 0 %
Packet Drop Rate 0 %
Jitter Buffer Length 100 ms
Received Interarrival Jitter 0 ms
DTMF Digits Received 0
Jitter Buffer Underruns 0
Jitter Buffer Overruns 0
Sequence number discontinuities 0
skew compensation 0 ms
send silence 0
This is the number I'd usually call to get on my work bridge..
Now is there a way to make this not audio only as you said a ways back so I can use dialpad?
Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page