obi100, no phone light, no dialtone = solved

(1/1)

normanc:
Hello every one
when I first plugged in the obi100 I had dial-tone.
I did a new installation through Obitalk add-devise and added Callwithus and everything worked fine.  Then about two hours later I tried to add Google voice by going to Obitalk = add-devise =I left configure with Google checked and I dialed the **5 number it rang a couple of times then the phone went silent, I waited about 2 min and hung up the phone. after that I had no dial-tone, both power and telephone lights were on.

I read about the factory reset and did that now the phone light is off.
I read about delete devise from Obitalk I did that.  
Now because I don't have dial-tone I can't add-devise for the obi100.  
Note; I can see the admin web page for the obi100.  

Shale:
You did factory reset, and still no dialtone? Bad phone, bad cable, bad OBi box  or bad OBi power supply, I would think.

normanc:
Thanks Shale
I triple checked every thing and it tuns out it was the phone cable.
I'm back in business! 

That was weird, that the wire to the phone would go bad while in the
middle of using it.  I took for granted that the wire was good because it was working.   

Navigation

[0] Message Index