HKBN 2B Obi110 or OBi100 settings
baor:
I am not sure if Obitalk Support team is testing my OBi110 or what.
My Obi110 is rebooting randomly????
QBZappy:
baor,
Off topic:
I use this to resize my images. You probably can reduce that image to under 128K and still be usable. I have done it. It works. It is Freeware.
http://www.faststone.org/FSViewerDetail.htm
baor:
Quote from: QBZappy on April 11, 2011, 07:21:55 pm
baor,
Off topic:
I use this to resize my images. You probably can reduce that image to under 128K and still be usable. I have done it. It works.
http://www.faststone.org/FSViewerDetail.htm
I know how to resize. It is about usability...
Please don't get offended. I am talking my time to capture screen. I wish I could upload and share them immediately.
Doing Post processing kills my mood....
baor:
Quote from: baor on April 11, 2011, 07:01:38 pm
Quote from: obi-support2 on April 11, 2011, 06:50:17 pm
If call is ended by the server, 2 things should happen:
1. Your call will disappear from the call status page (if you refresh the page)
2. If you don't hang up, you will hear some fast busy tone after 5s or so.
Did the last 2 happen?
Silence on both ends may not be a good indication the server has ended the call.
Or if the call still shows on the call status page (the one you attached),
what does it show for the number of packets sent and received?
If the call is still up, try this: hook flash on your phone, then hook flash again.
Does the audio resume?
Do you have a HK number? I could call you.
Hey, you reminded me something interesting.
I was talking to someone. At around 10 mins time frame, she said she could not hear from me. So she decided to flash and call me again. Her call hooked right back to my end while I was still talking to the phone (I didn't know it was dead on her end).... Does it help?
You are right.....
The call is still on. Packets are sending. But the phone is dead at exactly 10 mins...
obi-support2:
baor,
To answer your question regarding why bridging HKBN and GV has no audio...
From you previous HKBN call status, you were using G729 with HKBN.
However GV can only do G711U. To make this work, make sure your call to
HKBN is using G711U (you have to force it by disabling G729 and G726 codecs in the
codec profile). If HKBN indeed does not support G7111U codec at all, then there
is not way to bridge it with GV at the moment.
About the call has no audio on both ends (in your words "dead" or "cutoff") after 10 min, I cannot figure it out yet. All I can see is the OBi still sending out packets (tx packets increasing), but
no packets are coming from the server (rx packets not increasing). You can try hook flash, and hook flash again to see if the incoming packets will resume.
Again, a complete debug log will help with SIP Debug Options enabled will help us diagnose the problem further. If there is a size limit in posting, please email to support@obihai.com.
Navigation
[0] Message Index
[#] Next page
[*] Previous page