Success! (So far)... 911 test complete for the IP phone, and I can make and receive calls.
Now for the Obi202... I have a fax machine hooked to Phone 2 port, and when I call the secondary account number, it rings the fax machine. This is good.
Problem remaining is that the analog phone I have hooked to phone port 1 no longer rings, although it has a dial tone. My guess is that e911 is not configured as the reason. I noticed in the dashboard phone port config summary that phone 1 shows "Not configured" in both Primary outgoing and e911, with the other boxes blank. Phone 2 shows Primary outgoing, incoming rings, and v/m as SP1, with e911 "Not configured". This is confusing. What do I do to configure Phone port 1?
And as to e911 service, yes... both accounts are provisioned with e911. This is where the problem must have been started: when I click on the button "Anveo E911 Signup", I am directed to a page where the only choice is SP2 or greater. I am not falling into the trap of deja vue all over again.
>>>I just checked my Anveo account and both accounts show e911 service and SIP registered. I may be narrowing down the issue... ObiTalk is not configuring e911 for the ATA device. If I ask it to manually, (via the button mentioned above), then it will set up e911 as SP2. I am reluctant to do this. When I check e911 on this line, it reports successful. Ain't that a blast! I have a phone that (almost) works on phone port 1, but no incoming.
I just had a thought.... I could plug the analog phone into the line out of the fax machine as a work-around. Still wonder what to do about that Phone 1 port.