OBi202 new firmware?
NerdUno:
Also kills outbound OBiBT Bluetooth calls. I've opened a separate thread about it.
meerkat:
I got similiar bluetooth issue. but if I dial the whole phone number 1(areacode)+No, then it works, if I dial just the No (eventhough all phone has the same area code), then according the the obi202 webpage history, it actually tries to call (areacode) only. Seems the new firmware exppect using bluetooth, you must dial **8 then must proceed with 1
This bug might due to OBI changed some dialing logic to compensate the new usb-phone-line device, and breaks (or changed) usb-bluetooth logic
Dietrich:
Hi,
I logged into my ObiTalk and was informed there was a new firmware update for my OBi202. So, I followed the instructions and upgraded remotely. Now, I'm on software version 3.0.1 (Build: 4041). However, when I check my OBi202 admin page. It has the "Reboot Required" symbol on the upper right corner. I rebooted the device twice (once a cold boot) but still the message is still there? Anybody else encountered this problem?
gyromike:
I updated both 202s of mine one via the touch tone ***6 method and one via the web. I had not seen this thread prior to the update or i might have waited. Both worked properly. I did not see any extra reboot needed message. It did take a minute or 2. I was only 1 revision back prior to the update. I do not use the bt so I hope nothing else got broken.
It looks like you should make sure you are using a dynamic IP before you do the update.
Koby:
My experience at first appeared to be similar to that of gyromike - I had not seen this thread and used * * * 6 to update my OBi202 and it appeared to go fine, in fact this update seemed to complete more quickly than most previous ones. But now today I called * * * 6 again and is it telling me a software update is available, so I don't know if yet another update has been released or if it didn't actually get the first one - I suspect the latter after reading YongChen's post. Under Product Information it says it's running SoftwareVersion 3.0.1 (Build: 3932). It's been less than two days since I attempted the update so I should have received the new build, but maybe I didn't.
This OBi202 IS set to a static IP address on my local network, so maybe I'll hold off a few days and see if this issue is resolved.
Navigation
[0] Message Index
[#] Next page
[*] Previous page