NEED HELP CONNECTING (2) OBI110 FOR REMOTE PAGING ACCESS

<< < (3/8) > >>

miteldavid:
Ianobi, The Simplex does not answer ringing calls, but you can go off hook with an analog phone connected to Simplex page port and get Intercom dial tone. I will try your other scenerio and move Simplex PA port from Tel port to Line port on Obi110 #2 and reconfigure per your advice. Question how will the line port on the obi110 #2 pick up the call from OBi110 #1 and connect to Simplex PA port?

ianobi:
My mistake. The line port will put out a loop like an analogue phone, so should be ok.

This rule should direct the incoming call from #1 OBi to the Line Port and seize the Simplex Page Port:

#2 OBi
Voice Services -> SP2 Service -> X_InboundCallRoute: {li}

Your speed dial directs the call to #2 OBi port 5061, which is sp2. The above rule should do the rest - we hope  :)

miteldavid:
Ianobi, I reconfigured OBi110 per Instructions.

#2 OBi
Voice Services -> SP2 Service -> X_InboundCallRoute: {li}

When I dial 1# from phone connected to OBi110 #1. I get recorded message saying
(The number you dialed sp2av@10.100.11.5.5061 was rejected by service provider. reason 503).

I'm assuming it has to something with speed dial entry #1 sp2(av@10.100.11.5:5061) on OBi110 #1.

ianobi:
Try sp2(@10.100.11.5:5061) The reject message may be coming from the Simplex PA.

To see exactly what each OBi is receiving and sending you will need to look into Status > Call History. This can only be accessed via each OBi's local web page. Dial ***1 from the phone attached to each OBi's Phone Port and it will tell you the IP address. User Name and Password will be "admin".

miteldavid:
Ianobi,

I changed Speed Dials 1. sp2(@10.100.11.5:5061) on OBi110 #1. same message

call history shows on OBi110 #1 reads-

call 50 - 8/20/2013 -
terminal id - PHONE 1 - SP2
Peer Name - blank - blank
Peer Number - 100 - av@10.100.11.5:5061
Direction - outbound -outbound
08:34:01 - new call - blank
08:34:02 - blank - call connected
08:34:08 - end call  - blank


Thanks for your help on this one!

Navigation

[0] Message Index

[#] Next page

[*] Previous page