Ianobi,
sorry I posted the wrong call history report when I get back onsite tomorrow I will post the correct one's. On another note I programmed Obi110 #2 Voice Services -> SP2 Service -> X_InboundCallRoute: {li} and connected Simplex PA access port to line port. I continued to monitor with test set (lineman's analog phone). When calling from OBi110 #1 to OBi110 #2 and rings I can hear from my test set the Simplex Intercom dial tone for a split second hear a burst of ringing, tone or even voltage breaks loop on PA system then call is connected at this point the simplex system is off hook before being connected to line and in this state the Simplex system is waiting for feature access code to be completed. On the calling side I can hear one ring the OBi110 #2 pickup and silence, I tried to dial any Simplex access code but get error tone from PA system instead. Is there any way to get rid of that burst of ringing, tone so it does not break loop on PA system before being connected? Could there be any digits being passed through line port of Obi110 #2 causing loop to break? Thanks!
QBZappy,
1) The OBi110 #2 does not work like I expect. When calling from OBi110 #1 to OBi110 #2 and rings I can hear from my test set the Simplex Intercom dial tone for a split second hear a burst of ringing, tone or even voltage breaks loop on PA system then call is connected at this point the simplex system is off hook before being connected to line and in this state the Simplex system is waiting for feature access code to be completed. On the calling side I can hear one ring the OBi110 #2 picks up and silence, I tried to dial any Simplex access code but get error tone from PA system instead. I connected my test set to phone port of OBi110 #2 when go off hook and dial # I'm immediately connected to Simplex PA intercom dial tone and able to dial any Simplex feature code access page feature. Works like a champ in this scenario. Both OBi110 are about 5-6 blocks from each other. (1) at the School District and (1) at a Elementary School. Cordless would not work for this set up.
2) I'd rather not use OBIAPP but if its the only way to get to work then it is an option.
3) The OBi110 are bridged using easy sip set up with IP and speed dial.This configuration is already set up. l
i=PA system connected to line port
a) OBi1=>OBi2 (via hotline or speed dial) using sip uri config (using speed dial config).
b) OBi2 inbound call route => li
The OBi paging method seem to work better I could call OBi110 #2 call is picked up automatically. after page tone, I was able to get intercom dial tone from Simplex PA system and dial Simplex feature code and access paging feature. The only problem under this scenario when I would hang up the phone the Simplex PA system would remain off hook and waiting for disconnect signal. PA access port is like a C.O. its as easy plugin in a analog phone going off hook getting intercom dial tone and dialing feature codes hang up to disconnect. It used to work when it was connected to Digital PBX trunk port at the school. Now they have a VOIP PBX at district and Per nodes at all school's that dont support trunk ports. I apologize for all my ranting about this set up and thank you guys for helping me out!