Delayed dial tone - Firmware issue?

(1/3) > >>

jilebi:
Hi,

I have a OBI110 and I upgraded the firmware to the latest one 2 weeks ago. Since then, when I pick up the phone, the dial tone comes on only after 7 seconds! The phone is silent till then. I have timed it consistently and every time it takes 6-7 seconds.

In addition, when I have an inbound call and I pick up the phone, I hear nothing for 3 seconds, after which I can start hearing the other party. Through multiple trials, including asking the other party, I have found that during that 3 second silence at my end, the other end continues to hear the bell ring.

Effectively, for outbound calls I now have a 7 second delay and for inbound calls I have a 3 second delay, at the start of every call.

Finally, one new strange behavior is that for automated messaging systems (like Google Voice), sometimes the dial tones are not being recognized. I have to press the numbers either multiple times or keep the same number pressed for a long time.

Can somebody please provide a solution?

Please help. The entire family is very frustrated with using Obi, over the last 2 weeks. It is just driving us nuts.

drgeoff:
Hmm!  This appears to have some commonality with http://www.obitalk.com/forum/index.php?topic=6548.0.

jilebi:
Exactly! That is also what is happening to me. In addition, I also have the delayed dial tone issue.

I am surprised that more people are not reporting this issue.

jilebi:
Any resolution to this issue?

Between the delayed dial-tone, delayed pick-up of incoming calls, and tones for automated voice systems not working, my wife is close to chucking the OBI device out of the house!

RFord:
I know you had a working setup before the firmware update, but have you tried a different phone and/or cables to eliminate that being the source of the problem?  If you bypass the router and connect the OBi110 directly to the Modem, does the problem persist?  Have you contacted OBi Support to see if they can provide some sort of detail diagnoses of the problem?  If the problem continues, what happens if you reset the device back to default and reconfigured?  Have you tried re-uploading the firmware manually to the ATA?

The reason they aren't much written on the subject is because most OBi110 users with the latest firmware is not having any type of issue.

Navigation

[0] Message Index

[#] Next page