UK Obi110 PSTN working fine, SIP inbound calls ring but cannot answer them

<< < (2/2)

Shale:
Quote from: derketo-rick on September 12, 2013, 06:17:50 am

There is still a delay when dialing out on SIP - what should I try to reduce that ?

Step 1 would be to enter # after you have finished dialing other digits. If that eliminates the delay you are talking about, then you could eliminate the need for dialing the # by adjusting a string or two.

ianobi:
Rick,

The starting point is to decide which service will be your "Primary Line". That is the default line where you don't have to dial any ** codes. The aim is to set up digitmaps that match the number formats for each service. This will reduce or eliminate delays. The Primary Line can be used to automate the routing of calls without the need for ** codes. Here is a UK setup that uses sp1 as the Primary Line.

http://www.obitalk.com/forum/index.php?topic=5362.msg34764#msg34764

Have a read through and come back with any questions specific to your setup.

Navigation

[0] Message Index

[*] Previous page