GV, OBI202 and Simon Telephony for Caller ID?

(1/3) > >>

tpir72:
Hi,
   Before I attempt to setup my OBI202 to use Simon Telephony as my caller ID.... I currently have the OBI202 to work with three Google Voice accounts and one E911 account. Once I follow Simon's guide: https://simonics.com/gvgw/help/ what will I need to change in my OBI202 config?

Is it true that every single outgoing call will have to be 1 - Area Code - Number, even for local calls with Simon as the Gateway?

Thanks for the help.

Regards,

Terry

N7AS:
To use the OBi202 with SimonGateway...

Example on SP1

Service Providers > ITSP Profile A > General
SignalingProtocol > SIP

Service Providers > ITSP Profile A > SIP
ProxyServer > (Provided by Simon Gateway)
RegistarServer > Same as above
UserAgentDomain > Same as above
OutboundProxy > Same as above

Voice Services > SP! Service > SIP Credentials
AuthUserName > Your SimonGateway Username such as GV1xxxxxxxxxx
AuthPassword > Secret provide by SimonGateway

Save each page before going to the next and then Reboot.

That's it.

I never use a 1 before the phone number.

tpir72:
Thank you very much!

With this setup, do you have to dial the area code for a local number?

Is there anything that is unavailable with this setup?

Regards,

Terry

N7AS:
If your DigitMap is setup for 7 digit dialing, then you don't have to enter the area code. I always dial the area code even for local calls. I have not ran into anything that is not available for my needs with SimonGateway.

Everton:
Quote from: N7AS on September 07, 2013, 10:45:26 pm

.
I have not ran into anything that is not available for my needs with SimonGateway.



Have you gotten voicemail notification (Stutter Tone or visual) to work with Simon Telephonics (ST)?  I have ST setup on my Panasonic KX-TGP551T04 IP Phone and it doesn't seem to work.

Navigation

[0] Message Index

[#] Next page