IPKall - Calls IN to Obi can hear me but I can't hear them

<< < (5/8) > >>

gderf:
{>anything:ph}

I think the problem is I need complete start to finish setup guidance for this SP via the OBi's webpage, or how to use OBiTALK to modify one of the built in canned configurations.

azrobert:
You setup this SP to block SIP scanners, but will also block calls from IPKall.

For a test try this:
{>anything:ph},{ph}

gderf:
I have started over using a clean SP4 (deleted then added back in again).

In my router, I have forwarded the appropriate UDP RTP ports 17100-17198 and port 5063.

X_InboundCallRoute is set to the default value of ph.

The OBi was then rebooted.

IPKall is set to forward calls to SIP URI: 123@my_IP_address:5063

When I place a call to my IPKall number I get a busy signal. The phone does not ring on my OBi and I see no blocked packets in my firewall log during the time of call.

I don't know where else to look.

azrobert:
Do you have a provider setup on SP4?

azrobert:
If SP4 is not defined, setup a dummy SIP definition like this:

Service Providers -> ITSP Profile D -> SIP -> ProxyServer : 127.0.0.1
Voice Services -> SP4 Service -> AuthUserName : (any userid)
Voice Services -> SP4 Service -> X_RegisterEnable : (unchecked)
Voice Services -> SP4 Service -> X_ServProvProfile : B

Navigation

[0] Message Index

[#] Next page

[*] Previous page