Eliminate Dialing delay??

(1/3) > >>

robhouston:
Hello:

Thanks to RonR's help, I've got my Obi110 to successfully dial +1 and 10-digit calls using my Google Voice account, and all other calls, including 7-digit local calls, are placed on the PSTN line.

However, when dialing 7-digits (and I haven't tested this for 911 calls), there is about a 4-second delay before the call is placed on the PSTN line.  I'm guessing this is because the Obi is waiting to see if more digits are dialed.

Is there a way to shorten this delay, perhaps to 2 seconds?

Thanks!

RonR:
Sure, simply change the S4 on the 7-digit rule to S2:


(1xxxxxxxxxx|<**81>[2-9]xxxxxxxxx|<**8>xxxxxxxS2|<**8>011xx.|<**8>xx.|(Mipd)|[^*]@@.)


You can also get into habit of entering '#' at the end of a number to tell the OBi you've finished dialing and there's no need to wait for more.


Edit: It just dawned on me that with no 'Sn' on the 7-digit rule, the timeout should be 2 seconds, so you can simply remove the S4 instead of changing it to S2.

robhouston:
RonR-----thanks for the very fast response! 

Regards,

Rob

frunple:
I just connected my obi110 and I'm getting a 8 - 10 second pause when using my PSTN line between dialing and actually connecting (ringing).
I have a GV as sp1, another GV as sp2 and comcrap in the line port.
I didnt change any of the default dial plans.
Where is this S4 entry exactly?

RonR:
Quote from: frunple on September 09, 2011, 03:26:58 pm

Where is this S4 entry exactly?


When dialing numbers destined for the LINE Port (PrimaryLine = PSTN Line or **8 + number), the default DigitMap used is:

Physical Interfaces -> LINE Port -> DigitMap : (xxxxxxxS4|1xxxxxxxxxx|xx.)

An improved LINE Port DigitMap might be:

Physical Interfaces -> LINE Port -> DigitMap : ([2-9]11|[2-9]xxxxxx|1xxxxxxxxxx)

Call processing will begin 2 seconds after [2-9]11 is dialed, and immediately after a 7- or 11-digit number is dialed.

Navigation

[0] Message Index

[#] Next page