OBI202 with Voxbeam

(1/1)

Gavo:
Hello,

I have tried to emulate setting up an OBI202 by following this thread http://www.obitalk.com/forum/index.php?topic=2898.0

However whilst it works perfectly OK with OBI110's I've setup, I can't get the 202 to work. All calls I make get routed to SP1 (the primary line) and result in a SIP480 code (presumably because of the route prefix for premium, direct etc. routes in Voxbeam).

When I try to register Voxbeam as SP2 - the registration shows "Register Failed: 405 Method Not Allowed", whereas with the OBI110 the message shows "registration Not Required".

Any ideas where I'm going wrong ?

Cheers

Gavin

Gavo:
Scrap that.

Reset it all and started again. All OK.

Will post again with the problem that has now arisen.

Navigation

[0] Message Index