OBI100 blinking red, nothing responds
jsip:
Hi,
I have an obi100 unit which worked great. Then yesterday, while on the phone it cut out.
I tried a factory reset, no luck, I tried to update the firmware, no luck.
The unit flashes green for a moment, then it starts flashing red rapidly, then it goes back to green, then it's flashing green then red slowly, then it starts the process over.
What can be done?
Shale:
http://www.obihai.com/OBiAdminGuide.htm
Power light Flashing Orange: The OBi is upgrading. DO NOT remove power!
I don't see anything that matches what you describe. You might try a factory reset.
jsip:
Well, would that i could.
Like I said earlier, I tried the factory reset. I had the unit on, all lines plugged in. Pressed and held the reset button for at least 30 seconds and nothing changed.
Unplugged ethernet cable, pressed reset button, nothing changed
unplugged phone line, pressed reset button, nothing changed.
azrobert:
A similar thing happened to my OBi110 over 2 years ago. I don't remember the exact symptoms, but it was looping like yours. I tried everything you did without success, but when I reconnected it to the internet it magically fixed itself. My OBi110 obviously had a much older firmware and I was trying to update the configuration when this happened. I doubt reconnecting to the internet will help you, but it's worth a shot.
jsip:
Thanks rob,
You said to reconnect it to the internet? Are you saying you pulled the Ethernet from it and voila, it was fixed when you reconnected? Or did you disconnect it from the internet via software? If so, how?
Navigation
[0] Message Index
[#] Next page