OBI100 blinking red, nothing responds

<< < (2/2)

azrobert:
The sequence of events was something like this:

Power re-cycle. Nothing.
Reset. Nothing.
Removed phone cord and ethernet cable and did another reset. Nothing.
Re-connected the ethernet cable and the looping stopped.
Logged on to the OBi110 and the configuration was intact, so the resets failed.

Lavarock7:
Perhaps the Obitalk configuration was sent down to the Obi when the internet connection was put back on.

I would go to Obitalk and delete the device, then disconnect all cables but power from the Obi and do the hard reset.

Then reconnect the obi to your internet and login and look at the configs. If there are still entries there, I would try the USE DEFAULTS ONLY buttons at the bottom of the pages.

Then I would go to Obitalk and add the device.

Navigation

[0] Message Index

[*] Previous page