Speed dial to post to url. Part of my Google voice 2014 workaround.
Roger:
Quote from: azrobert on April 29, 2014, 09:07:28 pm
Roger,
What you describe shouldn't happen. The first command gets executed only on startup and sets TPRM1 to equal $UDM0, so the URL shouldn't be executed until you dial a new number. It also shouldn't matter if you set Method to Periodically instead of System Start. You would just execute the script additional times setting TPRM1 to $UDM0.
Even if there was a logic error on startup that I don't see, the script would only be executed once, because the next command sets TPRM1 to $UDM0. Maybe if Speed Dial #99 was set to a null value would cause a problem. I didn't test that condition.
As I mentioned before the callback works great, but sometimes the configURL script would execute every 5 seconds even though I didn't dial a number (and the dialnum would be blank). Now I guess I see why. I usually use the obitalk portal and I didn't see anything wrong there, but yesterday I logged into the device itself and noticed that the Obitalk provisioning script uses TPRM1 as one of its variables, so that was probably the cause of my problems. I changed all the TPRMn to GPRMn in my configURL and hopefully that will resolve the problem.
sfcwtuOBI:
"change 12223334444 to your callback number (the phone number in Google Voice settings that rings on your Obi device"
What number is this? Is it the GV number? I tried it with my GV number, but obi device did not ring. It only works when I use my mobile number. Can someone help pls?
giqcass:
You must set up an incoming phone number for your Obi by getting a free DID from Callcentric, IPkall, or anyone else that provides them. You must then verify that number with Google Voice and set it up as a forwarding phone. Then Use that number as the Callback number.
Navigation
[0] Message Index
[*] Previous page