update fails

<< < (2/3) > >>

asterisk@ck-lee.com:
My problem is like the attached pictures

daibaan:
it is now 9:36pm 5/14, the availability notice for Obi-1-2-1-2286.fw was post 1.5 hours ago, however, the link for the new firmware is not working. ***6 also says no new firmware available

MichiganTelephone:
Try this link - it works for me:

http://www.obihai.com/firmware/OBi-1-2-1-2286.fw

ohbipap:
ok just  bought a second obi 100
cause the first one is good
altho i still haven't been able to update it.

can't update this or get it started either!

1.  Devices that have been added to OBiTALK will see an associated yellow triangle which can be selected to invoke an automated update process.
yellow triangle just takes me to web page with alternative methods


2.  Devices with version 1.2.0 (or above) can be updated via the touch-tone phone attached to the OBi. 
Dial *** 6 .  And confirm the update (if available).
method #2 of dialing **6 says "update available"
I press "1" as prompted and...  nothing happens.

3.  Users can download the firmware from the link below and follow instructions to manually update the OBi using a PC's browser opened to the OBi device management web page.
http://www.obihai.com/firmware/OBi-1-2-1-2286.fw  (2MB
So I try to get the webpage for the device by asking for the address
but the ip address returned by the system attendant is 10.0.0.3
and that does not get me to the obi device.
i guess that is because i have all the obis on a cascaded router that is daisy chained into the first router that comes off the modem
maybe that is the whole problem

.  Access the web page of the OBi device:
     -  From a phone attached to the PHONE port of the OBi dial * * * 1
     -  The IP address of the OBi will be read to you.
     -  Open a new browser window on your PC and enter the IP address of the OBi.
         E.g.  192.168.1.110
     -  When prompted, enter "admin" for username and "admin" for password. 
         If you have previously changed the password, use that instead of "admin."

3.  Now that you have accessed the OBi web page, go to the "System Management" - "Device Update" page.  From there, "Browse" to the firmware file you just downloaded above and click Update. 

4.  Wait for the OBi to restart (approx. 30 seconds) and you will be good to go.

jimates:
I would just plug the obi into the closest ethernet port to your modem. If you get a dial tone then dial ***6 and see if it updates. If the update is successful, then move it to where you want it and do the configuration.

You can use the expert configuration from the Obitalk portal.

Navigation

[0] Message Index

[#] Next page

[*] Previous page