*67 does not block my callerid

(1/2) > >>

cssobi:
if I use my PSTN POTS line directly (not through any obi) when dialing a *67 + 11 digit number it blocks my callerid to the 11 digit number I called.

However through my obi110 (just after a factory reset) it does not block my caller id.
Shouldn't it block it? Or does one have to configure setting(s) in OBI110?
If so which one(s) or documentation explaining that?

N7AS:
If you are calling using GoogleVoice, CID Call Block will not work.
GV does not allow blocking calls.

azrobert:
Change Star Codes -> Star Code Profile A -> Code 5 To:
*67(<li(*67>1xxxxxxxxxx<)>), Block CallerId, call($Code)

Then dial *6714805551212 and *6714805551212 will be sent out the line port.

Edit:

This will work using a phone connected to the Phone Port.
Are you trying to do this from Asterisk?

cssobi:
>This will work using a phone connected to the Phone Port.
>Are you trying to do this from Asterisk?
Yes want to do from asterisk and have 3 to as many  5 OBI202s that we want to route the call through asterisk to the OBI110:LI port and support such codes: *67 (block) but another effort need to support *82 (unblock), those are just 2 but may need to support more.

right now we are routing all 11 digit numbers through asterisk back through obi110:LI port .... just need to get these "prefix codes" supported/working

giqcass:
I'm not an asterisk expert but I think you just need to disable the *codes on the Obi that relate to the functions you want to use on asterisk.  

Navigation

[0] Message Index

[#] Next page