Obi 110 power light goes red and unit floods network

<< < (2/2)

Ad_Hominem:
Well, the problem recurred again today.

I was going to try changing the Network port from 10/half to 10/100, but I cannot find the setting.  Can anyone tell me where to look?

I have two Obi 110s.  Both are older hardware (with the relay that activates the PSTN line when the power goes out).  They are both in locations that are about 1,000 miles apart.  They both experience the same failures, but each only fails on days that I actually use the device to place calls using the FXS port.  Both devices receive all the calls that come into all of my numbers, and so incoming calls aren't the problem.  The problem has got to be something about the outgoing calls that I make.

I do make a number of calls that are prefixed by star codes that are not Obi codes.  In fact, I disable Obi's star code profile.  I wonder if there's a bug there...

Anyone else seeing this?  And is the Obi 100 also experiencing the same issue?  What about the newer hardware versions of the 110?

drgeoff:
Quote from: Ad_Hominem on December 20, 2013, 12:30:43 am

I was going to try changing the Network port from 10/half to 10/100, but I cannot find the setting.  Can anyone tell me where to look?
It isn't a setting you can do from a browser.

Switching an OBi's Ethernet ports to 100 Mbyte/s full duplex:

1. Dial *** (wait for response) then press 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot

Navigation

[0] Message Index

[*] Previous page