how do I send all of my soft phone calls to my PSTN?

(1/2) > >>

GreenGuy:
I want to use a soft phone to call out on my PSTN.  I can do this on my linksys SPA3102 unit, but I can't figure how to do it with the OBI110.

giqcass:
The way you set this up will depend on whether you plan to do it just on your local network or if you plan to also do it from outside of your local network as well.  What softphones and/or sip services are you using?  Obion is an option depending on the platform.

giqcass:
You can use a method like this but set your Auto attendants PrimaryLine to use your PSTN.
http://www.obitalk.com/forum/index.php?topic=6862.0
You can use one Callcentric account with multiple extensions or you could use any number of other providers.  You can require a pin number to dial out if you like.  Dial through is also possible.

GreenGuy:
I am not using a normal soft phone.  I am using an automated voice alarm dialing service provided by Ignition (inductiveautomation.com).  It uses SIP and is normally set up to port 5060.  The software works well on an ATCOM IP-01 as well as a Linksys SPA3102.  I am not using a provider on the internet, and I want all of my calls to go out over the PSTN (AT&T).  I am not interested in incoming calls at this time.

azrobert:
Can you point the service to the IP address and port of the OBi110? Port 5060 points to SP1 and 5061 points to SP2. Whichever one you pick must be defined as SIP.

Try a call after doing above. If it's setup correctly it will ring your OBi110 Phone Port. Answer the call and see if you have any audio problems. The next step is to add routing in the OBi110 to send the call out the Line Port. Post back and I or someone else will help with the routing.

Navigation

[0] Message Index

[#] Next page