Obi202 caller id blocking automatically on one voice service?
helloobi2014:
I have 2 voice services set up on my Obi202 - one is on Anveo, the other is Freephoneline.ca. I would like to permanently block the outgoing caller id on the freephoneline number (line 2) but not the Anveo number (line 1). Is there a way to do this automatically on the Obi without dialling *67 for all calls from line 2? Either a setting in the Obi, or a change in the digit map to automatically dial *67 for each outhoing call on line 2, or a setting on the freephoneline.ca website? I know that *81 would block outgoing caller id, but it does so for all the lines, not just 1, so it won't accomplish what I am looking for.
lk96:
there are probably few ways to do this.
One way that is probably simple enough would be to replace the:
{(<**2:>(Msp2)):sp2} term in the OutgoingCallRoute term for the Phone line you have your handset attached
to:
{(<**2:*67>(Msp2)):sp2}
This assumes that you dial **2 to place your call on
the sp2 "service".
I haven't tested the above to seems fairly straightforward to me.
If you try to accomplish something else, please respond to the post with more details.
L.
giqcass:
I have not tested this but you could try changing the profile for that sip provider on the Obi.
Service Providers
>>>>>>>>>>>>ITSP Profile X
>>>>>>>>>>>>>>>>>>>>>>>X_UseAnonymousFROM
EDIT: This setting may be just for sip connections. I still have not tested it.
helloobi2014:
I think I have solved this issue. I am posting here for anyone else who might search for a solution for the same problem in the future.
Under Voice services --> SP x service --> calling features, I have unchecked the box for AnonymousCallBlockEnable. I did not make any changes to the digit map.
Now, every call I make from that line shows up as "No Caller ID", unless I dial *68 before dialling (which temporarily unblocks Caller ID for that call). This is exactly the behavior I was looking for.
giqcass:
Quote from: helloobi2014 on January 24, 2014, 02:13:01 pm
I think I have solved this issue. I am posting here for anyone else who might search for a solution for the same problem in the future.
Under Voice services --> SP x service --> calling features, I have unchecked the box for AnonymousCallBlockEnable. I did not make any changes to the digit map.
Now, every call I make from that line shows up as "No Caller ID", unless I dial *68 before dialling (which temporarily unblocks Caller ID for that call). This is exactly the behavior I was looking for.
You are incorrect according to the Obi Admin guide.
Code:
AnonymousCallBlockEnable
Enable blocking of Anonymous Calls on this service. Anonymous calls are rejected with a SIP 486 (Busy) response and Call Forward On Busy service is not applied.
Note: It is possible for a user to set this parameter from the phone using a Star Code
Quote
AnonymousCallEnable
Enable masking of Caller-ID information for all outgoing calls. If enabled, the called party should perceive the call as coming from an anonymous caller.
Note: It is possible for a user to set this parameter from the phone using a Star Code
It's likely you set all outbound calls to Anonymous with a star code. You should check that both services aren't set to Anonymous.
Seems I was incorrect in my previous post as well.
Voice Services
>>>>>>>>>>>SPX1 Service
>>>>>>>>>>>>>>>>>>>>>>AnonymousCallEnable
Navigation
[0] Message Index
[#] Next page