Grandstream GXP2000 and OBi100
RonR:
Quote from: Tiger on July 30, 2011, 11:11:20 am
Answer: Both are the same subnet and behind the same router.
Then I wouldn't have expected one-way audio problems.
Take a look that the NAT Support Parameters in the SPA1001. FWIW, I have them all set to Yes in my PAP2. You might experiment with various combinations to see if they have any effect on your problem.
Tiger:
Quote from: RonR on July 30, 2011, 11:32:28 am
Quote from: Tiger on July 30, 2011, 11:11:20 am
Answer: Both are the same subnet and behind the same router.
Then I wouldn't have expected one-way audio problems.
Take a look that the NAT Support Parameters in the SPA1001. FWIW, I have them all set to Yes in my PAP2. You might experiment with various combinations to see if they have any effect on your problem.
Something wrong when call made from SPA1001, the log shows state is ringing even both connected, and one of peer RTP address is 0.0.0.0
Terminal ID SP2 SP2
State ringing connected
Peer Name
Peer Number pap2 1xxxxxxxxxx
Start Time 19:23:36 19:23:36
Duration 00:00:07 00:00:01
Direction Inbound Outbound
Peer RTP Address 0.0.0.0:0 208.x.x.x:63766
Local RTP Address 192.168.1.28:16834 192.168.1.28:16836
RTP Transport UDP UDP
Audio Codec tx=G711U; rx=G711U (bridged) tx=G711U; rx=G711U (bridged)
RTP Packetization (ms) tx=0; rx=20 (bridged) tx=20; rx=0 (bridged)
RTP Packet Count tx=0; rx=92 tx=92; rx=92
RTP Byte Count tx=0; rx=15824 tx=15824; rx=15824
RonR:
I don't see that probem here.
Tiger:
Issue resovled after set the following in SPA1001
Use Outbound Proxy: yes
Outbound Proxy: <Obi SP2 Ip address>:<port> - the same as Proxy value
Use OB Proxy In Dialog: yes
RonR:
That must be a quirk in the SPA1001 as I have them both set to No in the PAP2 and no Outbound Proxy specified.
I'm glad you found a solution.
Navigation
[0] Message Index
[#] Next page
[*] Previous page