Can't find Call History under Expert Config: Obi110 or Obi200
MikeHObi:
Quote from: drgeoff on January 24, 2014, 11:36:17 am
Username is admin. Default password is admin.
Password for the webpage has been added to ObiTalk. So username is admin, but password may be the password you setup in ObiTalk when you configured your device.
DianaNathan:
I was able to access the Call History.
Thank you, all, for your assistance.
WM94:
Quote from: gderf on January 24, 2014, 08:20:06 am
http://your.obi.ip.address
I tried this last night, but was not able to connect. My computer is setup to the router wirelessly, and the Obi202 is wired. Will both need to be wired for this connection? Can OpenDNS mess things up?
MikeHObi:
Quote from: WM94 on February 20, 2014, 06:48:07 am
Quote from: gderf on January 24, 2014, 08:20:06 am
http://your.obi.ip.address
I tried this last night, but was not able to connect. My computer is setup to the router wirelessly, and the Obi202 is wired. Will both need to be wired for this connection? Can OpenDNS mess things up?
By default the OBI does not expose the web admin page on the internet connection. You may need to change that configuration (make sure you then use a strong password) to have it available to your computer.
WM94:
Quote from: MikeHObi on February 20, 2014, 09:20:47 am
By default the OBI does not expose the web admin page on the internet connection. You may need to change that configuration (make sure you then use a strong password) to have it available to your computer.
Is that also setup through the handset? I dialed ***0, 30#, 1, 1#, 1. I thought that enabled web config. I found this http://www.obihai.com/faq/OBi202-sec/Howto-Access-Web-from-WAN, and followed the directions at the bottom of the page using ObiTalk. Even though I did the dial access, AccessFromWAN was disabled. Now that it is enabled (with stronger password), I will try it again tonight.
Navigation
[0] Message Index
[*] Previous page