Alarm system not taking incoming call (ring issue?)
MikeHObi:
Quote from: giqcass on February 04, 2014, 05:59:35 am
What is the model of the alarm?
Z64 as noted above. I'm pretty sure it is close to this model
http://yy-electron.com/z64usermanual.pdf
Thomasvs:
It is basically the same alarm system as shown on the PDF.
The only difference is that the version shown works with a SIM card / cellular service.
Mine works via regular phone line.
giqcass:
Sorry, read the post but I somehow missed the answer. I'm going to look things over and see if I can see anything useful.
RFord:
Quote from: Thomasvs on February 02, 2014, 12:29:33 pm
.
.
I wonder if the voltage needs to be higher than the 82 volts that the system allows (It can be set from 55 to 82). I read that the standard for a regular land line is 90VAC.
Any suggestions? ???
From memory, the normal setup to approximate a PSTN line is:
Ring Wave Form: Sinusoid (OBi ATA = Sinusoidal)
Ring Voltage: 90 (OBi ATA only goes to 82; not sure what happens if you enter 90 in the box provided)
Ring Frequency: 25
CWT Frequency: 440@-10 (not sure where you would enter this value on the OBi ATA)
Do you have a spare PAP2T-NA or SPA3102, etc., where you can register this ATA (with VOIP.ms) with the values posted above to see if it makes a difference?
RFord:
Quote from: QBZappy on February 01, 2014, 07:26:07 am
@RFord
I'm too curious, I need to ask if you are the mayor of Toronto (Canada)? :D
Only when I'm high on crack cocaine or defaulting to my Jamaican accent ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page