busy signal all the time for outbound calls
giqcass:
Quote from: mishal on February 09, 2014, 03:20:01 pm
Hi azrobert,
I used to do both yesterday as I was playing with the unit then I tried to add my ONSIP account as SP2 but it wouldn't stay registered. I found a post here that recommends disabling the autorevision, I did that and my SP2 (ONSIP.COM) managed to register and stay registered. so, I am now updating OBI110 from the unit itself. my successful setup yesterday was after doing all of this and things were fine. now I can not use the speed dials as it gives the busy signal for all of them. without speed dial, I can not call my onsip number from the handset since I programmed my *3 speeddial to dial sp2(XXXXX@getonsip.com) to go through my second SiP provider ( I guess you already know this ).
Don't dial a * before your speed dial. Instead dial 3# or dial 3 and wait for the timeout.
mishal:
Thanks giqcass ! it worked !
just curious, why did *1# work before ?
I have to say that the community here is awesome and very helpful. Thanks for all the responders.
giqcass:
Quote from: mishal on February 09, 2014, 03:46:23 pm
just curious, why did *1# work before ?
*1# should not have worked. It's possible there was a DTMF error.
Welcome to the forum!
Navigation
[0] Message Index
[*] Previous page