OBiLINE - FXO to USB Phone Line Adapter

(1/2) > >>

Hortoristic:
Is the "OBiLINE - FXO to USB Phone Line Adapter" how I can hook up a PSTN to my Obi202?  I could for example plug in my XFinity Voice land line?

If true; is it any harder to configure to make my 202 dial out on e911 on it or make general outgoing calls - any harder than configuring any other SP?

drgeoff:
Yes.

No.

Hortoristic:
So using the admin interface to the OBI202 device (not Obitalk) - I want it to change my default dial out provider through the OBILINE instead of currently its SP1.  

Can you provide the syntax - I'm guessing instead of SP1 it would be PSTN?

I think:
Physical Interfaces > Phone1 Port > Phone Port > PrimarLine=PSTN Line would change my default dial out to PSTN (obiline).

And what about my 911 - I was using voip.ms but am going to revert to my Comcast PSTN line - is my 911 entry below correct - it used to say {911:sp2}:

{911:PSTN},
{([1-9]x?*(Mpli)):pp},
{(<#:>):ph2},
{(<**8:>(Mbt)):bt},
{**0:aa},
{***:aa2},
{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},
{(<**3:>(Msp3)):sp3},{(<**4:>(Msp4)):sp4},
{(<**9:>(Mpp)):pp},{(Mpli):pli}

azrobert:
I don't have an OBi202, but I assume the Line Port would be defined the same as an OBi110.
You have 3 choices.

{911:li},

{911:pli},

pli points to the Primary Line, so if you want to revert back to SP1, you just have to change the Primary Line.

Delete {911:sp1} and don't replace it.
Add 911| to the Line Port DigitMap.

The last rule {(Mpli):pli} points to the Primary Line DigitMap and Trunk.

Hortoristic:
Not getting your step "Add 911| to the Line Port DigitMap." ?

Line Port DigitMap is currently:
(xxxxxxxS4|1xxxxxxxxxx|xx.)

Navigation

[0] Message Index

[#] Next page