OBiLINE - FXO to USB Phone Line Adapter

<< < (2/2)

azrobert:
Set it to:
(911|xxxxxxxS4|1xxxxxxxxxx|xx.)

The xx. in a digit map will delay the outbound call unless you end the dialed number with a #

IMHO the following is a better DigitMap:
(911|xxxxxxxS4|1?xxxxxxxxxx)

The 1?xxxxxxxxxx will match a dialed number with or without the country code (10 or 11 digits).

Hortoristic:
I have noticed quite a delay now since I started dialing through Comcast instead of GV, is that related to this setting?

giqcass:
The settings for the line port will not show up until the Obline is actually plugged in.  My suggestion is to test the obiline after you plug it in (to the obi and the outgoing line) by pressing ##.  That should give you the dial tone.  If it doesn't you may need to reset the digit maps and OutboundCallRoute on both phone ports to default.

Then add {911:li}, to the outbound call routes in both phone ports.  

Hortoristic:
Been making calls ok, incoming and out. Just the as expected annoying thing is outgoing calls can't be spoofed so people are seeing my Comcast number. But now that I got the 911 sorted I can cancel voip.ms for e911.

Voip.ms despite my long relationship wouldnt offer me a plan that was cheaper than a penny a minute. 2,000 minutes would have been $20. Not very flexible of them. I still use them for out of country calls though.

giqcass:
For those of us that had modified our DigitMaps / OutboundCallRoutes before the Obline even existed their are missing references in the DigitMaps / OutboundCallRoutes that are needed for full functionality of the obiline.  That's why I suggested testing ##.  Obihai doesn't mention that anywhere in the installation guide.

Navigation

[0] Message Index

[*] Previous page