Use ObiTalk 110 only for dial-tone?

<< < (2/2)

azrobert:
This DigitMap will allow 10 or 11 digit dialing:
(<480>xxxxxxxS4|1?xxxxxxxxxx|011xx.)

There are a couple other parms you might want to change under
Physical Interfaces -> Line Port

RingDelay is set 4000 milliseconds.
This will delay incoming calls from ringing for 4 seconds.
It's used for processing the CallerID.
Do a search on the forum for RingDelay for a detailed explanation.
You should be able to set it to 0

The OBi110 uses Silence Detection to determine if the person on the other end has hung up, so if they put you on hold for 60 seconds you will be disconnected.

Uncheck DetectFarEndLongSilence

jeffdod:
All good info. Thanks, folks!

Navigation

[0] Message Index

[*] Previous page