Obi110 stops working
M105:
I have noticed that if I disconnect the network cable from my Obi to my router for whatever reason and then reconnect the cable, the Obi doesn't always recover. It will sit there forever like you describe and give you the error message when you try to make a call. This may sound overly simple but check your cable connection or swap it for another cable.
RonR:
Quote from: M105 on April 29, 2011, 08:31:09 pm
I have noticed that if I disconnect the network cable from my Obi to my router for whatever reason and then reconnect the cable, the Obi doesn't always recover. It will sit there forever like you describe and give you the error message when you try to make a call. This may sound overly simple but check your cable connection or swap it for another cable.
FWIW, here's what I see related to Ethernet cable disconnections:
1. Less than 10 seconds : Normal operation resumes as soon as the Ethernet cable is reconnected.
2. More than 10 seconds : The power LED blinks. As soon as the Ethernet cable is reconnected, a reboot occurs and normal operation resumes.
Reboot Reason Code : 13 - Reboot on Data Networking Link Re-establishment
yhfung:
I have experienced the same situation as Jeffy. I have not modified anything except powering up the device. It was suddenly not able to work anymore.
Finally, I disabled the DHCP service and use the static ip, gateway, dns, my OBi110 worked again.
I believe whenever OBi110 has any problem, try to solve the problem by applying the method shown above.
YH
Navigation
[0] Message Index
[*] Previous page