Will Anveo Direct work with Obi devices?

(1/2) > >>

UserKL:
Will http://www.anveodirect.com/ services (termination & DID) work with Obi? if anyone's using it, care to share configuration tips? thanks

SteveInWA:
That's Anveo's wholesale site.  See their main website for the consumer offering that works fine with OBi boxes.  In fact, Obihai chose Anveo as their partner for their new packaged offering.  Read through the forum.

http://www.anveo.com/

UserKL:
It's both for wholesale and personal use. Someone on dslreport reported success setting up outbound calls on the obi202, using a voice gateway. Can any guru enlighten me how it can be done based on the information below? thanks

Can I SIP Register to Anveo Direct?
Anveo Direct does not support SIP Registration and incoming calls are forwarded to SIP URI.

Sending calls though Anveo Direct is easy!

1. Configure Outbound Trunk(s)
2. Send calls from authorized IPs to:

[PREFIX]PHONENUMBER@SBC.ANVEO.COM

where [PREFIX] is your custom configured prefix for the trunk and PHONENUMBER is destination phone number with country code.

Anveo Direct uses IP authentication for outgoing calls and incoming calls are sent to SIP URI so there is no need to "register" SIP server.
To place calls though Anveo Direct you need to create a peer as following

[anveo_direct_out]
type=peer
host=sbc.anveo.com
port=5060
insecure=port,invite
canreinvite=yes
disallow=all
allow=ulaw

giqcass:
It's the same basic service.  The setup appears slightly different.  Does it actually provide a cost benefit over Anveo for consumers?  What are the rates? What are the minimums?

Primary issue I can see for setting this up.  You probably have a dynamic IP address.  The cost benefit would have to be pretty good to deal with the extra hassle.

UserKL:
The rates are definitely worth it. Technically, how would I go about adding the prefix to the dial string? On FreePBX etc, I believe there's a setting for "Custom Dial String" SIP\[prefix]$out_num$@sbc.anveo.com

Sending calls though Anveo Direct is easy!
1. Configure Outbound Trunk(s)
2. Send calls from authorized IPs to:
[PREFIX]PHONENUMBER@SBC.ANVEO.COM

How can I make the obi do that?

Navigation

[0] Message Index

[#] Next page