Use Obi110 to bridge Yealink T46 to PSTN Line

<< < (3/4) > >>

Fordvw:
I also did some more research and discovered that some SIP ALG functions on routers create problems by messing up the IP's in headers. I have a ZyZel ZyWall 50 Firewall/Router which has it on by default. Could this also be creating issues?

Thanks, Ford

azrobert:
It's always a good idea to turn off SIP ALG, but I don't think it's causing this problem.

Are you sure you changed the correct UserID on the Yealink? Maybe it's AuthUserID.

Anyway, it doesn't matter. Change the Inbound route to:

{10.0.1.44>(Mli):li},{ph}

azrobert:
Here are a couple nasty things about the OBi110 Line Port settings.

RingDelay default is 4 seconds (4000 milliseconds). The OBi110 will start ringing 4 seconds after a call comes in. This delay is needed to process the CallerID. I have mine set at 3000, but you can probably set it a little lower. If you set it too low CallerID will not display on the Yealink.

The OBi110 uses Silence Detection as one of several methods to determine when the other end hangs up. The default is 60 seconds, so if you are put on hold for 60 seconds the OBi110 will hang up. It's up to you if you want to disable or increase the value.

Fordvw:
Changing the Yealink to the IP address worked in the Inbound under Line!  Thank you for your help.  Much appreciated.

Also, your other comments relative to the Obi110 are very helpful.

Thanks, Fordvw

giqcass:
Quote from: azrobert on February 22, 2014, 07:47:22 am

Here are a couple nasty things about the OBi110 Line Port settings.

RingDelay default is 4 seconds (4000 milliseconds). The OBi110 will start ringing 4 seconds after a call comes in. This delay is needed to process the CallerID. I have mine set at 3000, but you can probably set it a little lower. If you set it too low CallerID will not display on the Yealink.

The OBi110 uses Silence Detection as one of several methods to determine when the other end hangs up. The default is 60 seconds, so if you are put on hold for 60 seconds the OBi110 will hang up. It's up to you if you want to disable or increase the value.



Thanks for that info!  I was not aware of the Silence Detection issue.  I just got an Obi110 when they had the presidents day special.

Navigation

[0] Message Index

[#] Next page

[*] Previous page