Use Obi110 to bridge Yealink T46 to PSTN Line

<< < (4/4)

azrobert:
Quote from: giqcass on February 22, 2014, 01:42:42 pm

Thanks for that info!  I was not aware of the Silence Detection issue.  I just got an Obi110 when they had the presidents day special.


I wasn't aware of it either until it bit me.

I was talking to Dell support and the rep would put the phone down while checking something on the computer and we kept getting disconnected. That's when I checked into it.

jd3030:
Basic question...
Does this setup allow you to use the line for google voice or are you just using it as a bridge?

I want to try and setup google voice with my yealink phone.  I have done a lot of research, but yet to find a clear solution.

azrobert:
You can direct the call from the IP Phone to any trunk defined on your OBi.

Assuming GV is defined on SP1 make the following change:
X_InboundCallRoute: {yealink>(Msp1):sp1},{ph}

You need to define the dummy trunk on SP2
Also include the following parm:
Voice Services -> SP2 Service -> X_ServProvProfile: B   


What model OBi do you have?
If you have an OBi1xx then the IP phone must be able to call without registration.
You can register an IP Phone to an OBi2xx.

xiaonvren:
Thank you for your suggestions. They are very helpful. I like your idea of zero in the Registration Period.







_______________________
my site:cheap fifa coins

Navigation

[0] Message Index

[*] Previous page