How does SipSorcery work with GV
corporate_gadfly:
Quote from: giqcass on April 09, 2014, 06:49:06 pm
Thank you very much for the link!
You're welcome. Glad I could help. I have gained a lot from these forums over the last few months. It's time to pay back a little.
Both NJ and LV are in stock at the moment.
KAura:
Quote from: simpleAnswers on April 10, 2014, 01:13:08 am
I guess I will still need to have it setup with my domain info correct?
not sure, but probably NO (unless your ip is shared)
if you have a dedicated ip, then using your ip
xxx.xxx.xxx.xxx is all that should be necessary,
and you will avoid the latency from using a dns server.
If you are using a shared ip, far as I know you will have
to use a domain name, although you might be able to
get around it using different ports (possibly).
corporate_gadfly:
Quote from: simpleAnswers on April 10, 2014, 01:13:08 am
The VPS appear to be available to buy, however my question was if I was just trying to test out, I guess I will still need to have it setup with my domain info correct?
Finally, are there latency issues I should be concerned about with regards to where Asterix is hosted?
Sorry, I missed your post.
So, no you don't need a domain. You can use a straight IP address.
Latency should not be a concern as long as you are not crossing continents. In general, as close as possible is better (so inside your home network is ideal). So, if you are on the west coast, it would not be advisable to get a host with their data center on the east coast.
If latency becomes an issue down the road, I will pop for a Raspberry Pi and stick it in my home network.
simpleAnswers:
Quote from: corporate_gadfly on April 11, 2014, 12:43:33 pm
So, no you don't need a domain. You can use a straight IP address.
So I need to provide my IP address and 2 nameservers before I can purchase?
Another question which would seem silly but seriously I can't connect the dots in my head.
Question is how would I then use this configuration with the Obi?
I can understand receiving calls via my DID as my callcentric is configured as SP4 on my OBi202. So incoming calls to GV are forwarded to it and it rings on the OBi.
But How do I dial out with the OBi via this Asterix GV callback? Surely I have to configure the Asterix somehow on the OBi also. Unless you are using some other ATA device instead.
KAura:
When you lease a vps, you are assigned an ip.
Navigation
[0] Message Index
[#] Next page
[*] Previous page