Multiple phone ports and Call waiting.
OneForTheTeam:
Here's my setup. ObiVoice as SP1. Phone port 1 - Panasonic cordless base. Phone port 2 : GE corded handset for emergencies. Incoming calls routed to ph1,ph2. With this setup the second call on SP1 rings phone 2 instead of a call-waiting tone on phone 1. Is there any way in Obi to do the following?
As far as incoming calls are concerned treat Phone port 1 and port 2 as if it were a splitter within Obi.
So incoming calls will ring both the phones and call waiting will generate a tone on either of the phones which is currently handling the inbound call. However, when a single call is active on one of these phones, I still need the ability to dial out from the other phone. Hope this makes sense.
(FYI the day after my number ported to VOIP from POTS, we had a power outage lasting many hours testing my setup :o. UPS --only OBi and router on it to maximize backup coverage --and the corded phone did its trick.)
azrobert:
I don't have an OBi202 so I can't test, but I think Call Waiting should work even if you're forking the call to PH2.
Make sure Call Waiting is enabled. You can check CallWaitingEnable under the Phone Port settings or just dial *56 to enable it.
OneForTheTeam:
Quote from: azrobert on February 24, 2014, 09:20:04 am
but I think Call Waiting should work even if you're forking the call to PH2.
Thanks. I did not know that is how the Obi operates. I assumed ringing of PH2 when PH1 is busy was normal Obi mode of operation. I just used the default configuration of ITSP profiles and Service Providers w.r.t call waiting after a device wipe. I'll check my Obi again when I get home.
BigJim_McD:
Several VoIP SIP service providers allow two concurrent calls. A combination of two incoming, outgoing, call waiting and 3-way calling.
For a single VoIP SIP service on a Obi202 device, in ObiTALK Settings for Obi202 and with CallWaitingEnable "Enabled/Checked".
Set "Primary Line for Outgoing Calls: Phone 1 SP1 & Phone 2 SP1
--AND--
Set "Phone Rings on Incoming Calls from: Phone 1 SP1 & Phone 2 Blank
X_InboundCallRoute: {>12345:ph1}
Allows: 1-Call and 1-Call Waiting -or- a 2nd OGT Call on ph2
--OR--
Set "Phone Rings on Incoming Calls from:
Phone 1 SP1 & Phone 2 SP1
X_InboundCallRoute: {>12345:ph1,ph2}
"Allows: 1-Call on ph1 (INC or OGT) and 1-Call on ph2 (INC or OGT).
The "X_InboundCallRoute" can be verified by using the ObiTALK OBi Expert Configuration and checking: "SP1 Service" - "X_InboundCallRoute" field.
>12345 would be replaced by your SIP account user name.
OneForTheTeam:
Just checked my settings and Call waiting is enabled for Ph1 and Ph2. Can anyone else confirm the default behavior? In my case on a second incoming call I hear no tone on ph1, but ph2 rings when a call is ongoing on ph1.
Navigation
[0] Message Index
[#] Next page