InboundCallRoute Explained
pvpham:
I would like inbound call to ring 2nd cell phone and 2nd cell phone to make direct call.
I change the X_InboundCallRout: to {pvpham|userid2>(Msp1):sp1},{101|102>17771234567:aa},{ph}
userid2 is Sip2Sip account of 2nd cell phone.
102 is extension of Callcentric for cell phone 2
is the above code correct ?
on cell phone 2:
Register Callcentric
Register Sip2Sip
Set filter rule for Sip2Sip
What-else do I need to do ?
Thanks
azrobert:
Your config looks good.
m, M, s, S, x, X are reserved characters. If you have any of these in your UserID they must be in quotees like this:
{pvpham|u's'erid2>(Msp1):sp1},{101|102>17771234567:aa},{ph}
If that's not the case then do the same routine as the 1st account.
Check Sip2Sip call history and everything I said to check on the cell
azrobert:
Quote from: azrobert on March 09, 2014, 09:38:01 pm
m, M, s, S, x, X are reserved characters. If you have any of these in your UserID they must be in quotees like this:
{pvpham|u's'erid2>(Msp1):sp1},{101|102>17771234567:aa},{ph}
I gave you false information. This only applies when the test is a DigitMap (enclosed in parentheses) like this:
{(pvpham|u's'erid2)>(Msp1):sp1},{101|102>17771234567:aa},{ph}
Ignore what I told you.
pvpham:
I run into a set back when adding a second cell phone into the scheme:
For some reason, the CSipSimple apt that I installed in my second cell phone does not have the Filter function in its setting. I guess that because the operating system for my second cell phone is old ( Android 2.3.5, Gingerbread) that make the CSipSimple adapted itself to the old version. I can not set the filter rule for the Sip2Sip
Is there any way that I can put a filter ( Suffix with @myIP:port) somewhere in the OBi code ? instead of on the cellphone side
azrobert:
I setup CSipSimple on an older version than 2.3.5. and it had filters.
Filters are the last option under settings.
Are you scrolling down far enough?
Filters must be on the cell.
Navigation
[0] Message Index
[#] Next page
[*] Previous page