Obi100 - 2 Sips setup - how to

<< < (2/2)

BigJim_McD:
You can not use the web admin interface (device IP) and also use OBiTALK to configure your OBi device(s). 

If you want to use OBiTALK, you can make additional changes using the OBiTALK > "OBi Expert Configuration" that will allow you to make changes on most of the OBi device settings that you see when connected to the OBi device admin web page.

drgeoff:
Quote from: gderf on March 07, 2014, 10:56:56 am

I believe you have to use the OBiTALK portal to set this. Have you tried that?

I believe that is untrue.
On the local web GUI:  Physical Interfaces, Phone Port, (Phone Port section) Primary Line - untick the Default box and select SP1 or SP2 from the pulldown.  Click Submit and reboot.

(By default the Primary Line will be SP1 on all Obis except an OBi110.)

drgeoff:
Quote from: vskatusa on March 07, 2014, 09:44:26 am

I am fully aware that you can configure 2 SIPS in Obi100 -ITSP Profile A & B.

1. Is my above understanding correct?
2. If so, how do you decide which SIP to use for outgoing calls?

You can also craft dial plans such that the OBi automatically uses SP1 or SP2 depending on the number dialled.  (No ** codes need to be prepended when dialling.)

Navigation

[0] Message Index

[*] Previous page