PhonePower for Obihai

<< < (3/3)

BHochstrasser:
I don't know if this helps or not, but I have a couple of Obi100 devices and I was able to go through the PhonePower setup a couple of times without any major issues.  Because they auto-provision, here are the steps I took.

De-coupled any provider from SIP1 and SIP2 on the Obi100.
Deleted the Obi100 from ObiTalk.
Using a paperclick, held the reset for 15-20 seconds until I got a fast blinking green light to properly factory reset.
From ObiTalk, Add New Device.
Entered the "**5-xxxx" code from my phone handset to register the factory reset device with ObiTalk.
Setup new provider for Obi100 within ObiTalk, choosing PhonePower.
Entered my existing PhonePower login credentials.
Choose the correct Obi100 and SIP1.
Done!

JohnnyP:
Quote from: giqcass on March 16, 2014, 06:41:42 pm

Quote from: Weiyi on March 15, 2014, 11:02:58 pm

Hi,

I clicked through the link on obitalk, registered and paid for phone power service. It worked. Unfortunately I had it on SP4, and would like to move it to SP1. I tried to remove SP4, and re-provision on SP1, but it asked me to pay again. How can I re-provision phonepower on Obihai?

Thanks,


For reference there is no need to switch a provider from slot SP4 to slot SP1.  Any service provider can be set as the primary incoming/outgoing service for any port and for the AA.  It's just easier to do that then it is to switch slots.

In order to fix your issue now you should contact Obihai with a support ticket.  They will probably just reprovision it for you.


Can you help me understand what you said in this post? I have GV on SP1, Phonepower on SP2. Should I leave it like this and just set SP2 as the primary incoming/outgoing service?

Thanks

Navigation

[0] Message Index

[*] Previous page