Newbie needs help setting up local line

<< < (2/2)

drgeoff:
1.  I assume you have checked the local phone service by plugging your phone into the VoIP box.  (If that isn't working, nothing you do with the OBi will fix it!)

2.  Check that Physical Interfaces, Line Port, InboundCallRoute is set to ph.  That is almost the only setting needed to make incoming calls to the Obi's LINE port go through to the phone.  If not working, the first suspect would be the cable you are using.  Is the OBi110's Line LED (the rightmost one) a steady green in standby and flashing when the local number is being called?

3.  When you take the Obi's phone off-hook, the dial tone you hear comes from the OBi.  That doesn't tell you anything about the local phone service.

asrjcb:
Okay,

Physical Interfaces, Line Port, InboundCallRoute is set to ph.
OBi110's Line LED (the rightmost one) is a steady green.  Can't dial local number to see it flash.  Assume everything here is okay.
When I take the OBi out of the setup, there is still a dial tone, but when I dial a local number - nothing goes through.   I think you hit it on the head, I have a local phone service issue.  I'm embarrassed.  I will call them and post again when I'm sure it's working.

Thanks so much again, especially if it was my stupidity.  Till tomorrow.

Navigation

[0] Message Index

[*] Previous page