CircleNet would like to introduce ourselves to the Obi world
azrobert:
Please check the following settings:
Service Providers -> SP3 Service -> X_ServProvProfile: C
Service Providers -> SP4 Service -> X_ServProvProfile: D
Next, you have a misunderstanding of Voice Gateways. Voice Gateways cannot register to a provider, therefore they can't be used for inbound calls. They can only be used for outbound calls when the provider allows calls without registration. CircleNet allows calls without registration, so it can be setup on a VG and I would recommend it be setup on a VG. Callcentric for inbound will have to be setup on a SPx trunk.
If GV is setup on SP2, then SP2 cannot be shared with a VG. VGs use the SIP protocol and GV uses XMPP. A VG must use a SPx trunk defined as SIP. Simon uses SIP, so you can share SP1 with a VG.
See my reply#60 in this thread to setup Circlenet on a VG. Use sp1(outbound.circlenet.us) and not SP2.
dial.tone:
Quote from: dial.tone on April 22, 2014, 12:19:45 pm
I will clear out all SP3 and SP4 settings back to their default values and redo the Callcentric and Circlenet setups on SP2, one at a time (Callcentric for inbound calls and Circlenet for outbound calls), just to verify to myself and the world that they (and I) work and post back.
Uh-oh, I just cleared SP3, SP4, ITSP C, and ITSP D back to their default settings and reconfigured SP2/ITSP B to receive calls via Callcentric and got the same error I had been getting on SP3 and SP4 [Register Failed: 401 Unauthorized (server=199.30.56.194:5060; retry in 117s)]. Same thing when I set it up to make outbound calls via Circlenet. Before, I had not problem getting Callcentric/Circlenet to work, individually, on SP2. I'm going to ask both providers to look at my accounts and see if they have been locked or something. If not, I'm at a loss.
azrobert:
See my previous post.
SP2 must be
Service Providers -> SP2 Service -> X_ServProvProfile: B
gderf:
Quote from: dudly on April 22, 2014, 03:31:36 pm
After reading this thread my head is spinning.
Configuring an SP slot using the OBITALK webpage portal is trivial.
Setting up a Voice Gateway is non-trivial in comparison.
dial.tone:
Quote from: azrobert on April 22, 2014, 02:41:51 pm
See my previous post.
SP2 must be
Service Providers -> SP2 Service -> X_ServProvProfile: B
azrobert, that must be the piece I have been missing. When I sent CallCentric some screenshots to help troubleshoot my "Register Failed" condition, here is what they said: "If you are using Profile B on SP2 then on your SP2 Service configuration page you need to make the following change:
X_ServProvProfile: B"
Same as you were saying, I just couldn't see it. When I made that change, SP2 registered with my Callcentric account. Now to go back into the Voice Gateway settings and see if I can get Circlenet configured to call out.
Navigation
[0] Message Index
[#] Next page
[*] Previous page