Can you stop the fast dial tone when you have a voicemail with Vestalink?

(1/1)

Holysmoke:
I have unchecked MWIEnable,   X_VMWIEnable   and MessageWaiting in the Obi100 GUI

I then save and reboot but it reenables itself and continues to give me the annoying rapid dial tone when I have a voicemail.

is there a way to disable that? thanks

Taoman:
Quote from: Holysmoke on April 11, 2014, 12:18:35 pm

I have unchecked MWIEnable,   X_VMWIEnable   and MessageWaiting in the Obi100 GUI

I then save and reboot but it reenables itself and continues to give me the annoying rapid dial tone when I have a voicemail.
I no longer subscribe to Vestalink but I thought there was a way you could disable it in the Vestalink web portal? I could be wrong about that, however.

As far as your Obi is concerned I assume you ran the Easy Setup tool from Vestalink? If so, your Obi is now using ITSP provisioning. To have the settings you've changed remain after a reboot you will need to disable ITSP provisioning.

System Management>Auto Provisioning>ITSP Provisioning

cluckercreek:
Just go into ObiTalk and disable it by clicking whichever SPx you are using. It is an option on the setup page.

KAura:
resistance is futile...
 we are vestalink...
  your obi...

will be assimilated!


I would contact vestalink indirectly via email
if it isn't already covered in the faq...

**you would think it's a control panel option**

otherwise, the ONLY recourse is to HARD reset
your device and do manual configuration...

which vestalink does not support  ::)

Navigation

[0] Message Index