Obi202 & Cisco SPA 303 IP Phone
Johntal:
I have my 202 all dialed in with Google Voice on SP1 and CallCentric on SP2. I would like to add my Cisco 303 to the 202. First question is do I have to use the OBiPlus service in order to add an IP phone? According to this Aug. 28, 2012 http://tinyurl.com/oalbnnz document it does not mention OBiPlus, but I followed the instructions, making sure to use SP3, and after a reboot of the phone it now just is stuck at "CheckingDNS". Any thoughts?
azrobert:
Try changing the parms on the IP Phone as follows:
Proxy = 192.168.1.100:5061
Register = No
Where 192.168.1.100 is the IP address of your OBi202
If there is no Register option, try it with registration.
WelshPaul:
Quote from: Johntal on April 17, 2014, 12:35:03 pm
I have my 202 all dialed in with Google Voice on SP1 and CallCentric on SP2. I would like to add my Cisco 303 to the 202. First question is do I have to use the OBiPlus service in order to add an IP phone? According to this Aug. 28, 2012 http://tinyurl.com/oalbnnz document it does not mention OBiPlus, but I followed the instructions, making sure to use SP3, and after a reboot of the phone it now just is stuck at "CheckingDNS". Any thoughts?
Yes you need to register for and use the OBiPLUS service if you want to use your Cisco SPA303 IP phone. Good news is you only need the basic/light subscription and that is free!
Just factory reset the phone and connect it via an Ethernet cable to the LAN port of your OBi device then log in over at OBitalk.com and setup and configure OBiPLUS and push the configuration to your OBi device, both will reboot and your done.
Johntal:
I will first try azrobert's response, that looks quick, but if that does not work then WelshPaul, I will move to the OBiPlus. One question with moving to the Plus, will I loose my current SP1 and SP2 configurations? Also seeing that I had to make modifications to my SP3 settings for the Cisco, if I use the reset at the bottom of the SP3 page will that only reset SP3 to factory?
Thanks again
drgeoff:
Quote from: WelshPaul on April 17, 2014, 09:40:21 pm
Yes you need to register for and use the OBiPLUS service if you want to use your Cisco SPA303 IP phone.
I think that is untrue. Read http://www.obihai.com/docs/OBi-VoIP-Device-Attach-Legacy-IP-Phone-Workbook-v1-0.pdf. No mention of OBiPLUS in that document.
Navigation
[0] Message Index
[#] Next page