Obi Hai setup

(1/3) > >>

turuncu:
My parents just got an obi hai box. Their set up is simple.  They would like to use land line for all local calls and would like to use a sip account to call overseas.

So anytime they dial 011 it goes through the sip and the rest including 911 goes through obi hai.

Also the sip requires 00 before the country code.  So when we dial 011XX it should be converted to 00xx.

Thanks for your help

Zeki

azrobert:
I assume you have an OBi110 and the Line Port is connected to the Land Line.
Do you have a VOIP provider and is it defined on SP1?

Assuming your VOIP provider is on SP1.
All domestic calls routed to the line port.
International calls routed to SP1.

Physical Interfaces -> Phone Port
Add to the beginning of the DigitMap:
011xxxxxx.S3|

It should look like this:
(011xxxxxx.S3|......Current Rules........)

Physical Interfaces -> Phone Port
Add to the beginning of the OutboundCallRoute:
{(<011:00>xxxxxx.):sp1},

Physical Interfaces -> Phone Port -> Primary Line: PSTN Line
This is the default.

Physical Interfaces -> Line Port -> DigitMap:
(xxxxxxx|1xxxxxxxxxx)

turuncu:
before I begin with the installation.  I would like to do a factory reset.  I have tried the rest from the web interface but. It does not look like it worked.  Is that a different way?

Thanks

gderf:
There is a hole on the bottom where you can push the reset button with a paper clip.

drgeoff:
Quote from: gderf on April 18, 2014, 02:25:04 pm

There is a hole on the bottom where you can push the reset button with a paper clip.

There is slightly more to it than just a momentary push with a paper clip.  See http://www.obitalk.com/forum/index.php?topic=28.msg46#msg46

Navigation

[0] Message Index

[#] Next page