Is it possible to have separate in/out providers on both sp1&2 on an obi100?

(1/2) > >>

zorlac:
I would like to use the free Callcentric #'s for inbound calls on two different numbers on sp1&2 and then use say VoIP.ms for the outbound calls on sp1&2.

I have been successful in getting GV to forward to the Callcentric freebe # configured on sp2 but I can't figure how to get the GV dialtone back on sp2 to dial out.

I'm new to this & it's a frustrating learning curve.

Thanks

drgeoff:
The literal answer to your question is "no".  You can only have one provider account on an SP.

However, you may be able to achieve what you want by using Voice Gateways.

Set up the SPs for the incoming calls.  Set up a Voice gateway for each of the outgoing providers/accounts.  There is a restriction that because Voice Gateways do not register with the provider, you need to use a provider which allows calls to be made without registering.  Some do and some don't.  I don't know which camp voip.ms is in.

Taoman:
Another option would be to forward your Callcentric number to a VoIP provider via SIP URI. You can then configure the VoIP provider on SP1 and configure your second Callcentric number on SP2. I am not sure if VoIP.ms allows this (without cost) but I know VoIP providers like Localphone and CallWithUs do.

Note: Some ITSPs that don't require outbound registration do require Prefix-Based IP Authentication (PIPA). IPComms for instance. This implies a static IP address from your ISP.

zorlac:
Like this?
Not that I really understand.... :D :D

hwittenb:
There are a number of ways you can configure to use a VoiceGateway for ALL outgoing calls.

One way is the following:

1.  Setup the Voice Gateway, say VG3

Name: voip.ms
AccessNumber: SP1(losangeles.voip.ms)
DigitMap: (1xxxxxxxxxx|xx.)
AuthUserID: your_userid
AuthPassword: your_password

2.  Setup Trunk Group 1
Name: voip.ms
TrunkList: vg3
DigitMap (Mvg3)

3.  Setup the Phone Port primary line to always use Trunk Group 1
PrimaryLine: Trunk Group 1

The above assumes SP1 is configured for Sip.

Voip.ms does allow you to make calls without registration and can be used in a voice gateway

Edit:  On 2d thought sending all outgoing calls thru the VG might cause trouble is you are setting up 911 emergency calling.

  

Navigation

[0] Message Index

[#] Next page