PhonePower Slow Call Setup
PeteMoss:
That corrects the problem but I am not VOIP savvy enuff to fool with the DigitMap.
Taoman:
Quote from: PeteMoss on April 20, 2014, 02:29:13 pm
That corrects the problem but I am not VOIP savvy enuff to fool with the DigitMap.
I guess I'm confused then. If you realize the problem lies with your DigitMap why are you blaming PhonePower? It has nothing to do with PhonePower. If you had the same DigitMap for VOIPo you would experience the same 10 second delay. Or perhaps I am misinterpreting your quote below?
Quote from: PeteMoss on April 19, 2014, 11:45:30 am
Still I find the PP call setup period really bad.
PeteMoss:
I merely used the the setup process that is available upon logging into ones OBIHAI account and recommended by OBIHAI to replace GV. The setup process is something that was determined by Phonepower in collaboration with OBIHAI. I might add that I used the OBIHAI/VOIPo setup process too (NOT a GV replacement) and have had no problems with that for over a year. The dialing plans come from the respective ITSP(s) and I am not real familiar with the syntax and rules to troubleshoot what I consider a defective a dialing plan. I also note that a poster to this thread did not have the same problem but I do not know if he used the new OBI/PP setup process. Perhaps I can find something on the PP site. Sometimes one can actually get help in a forum though.
UPDATE: The PP site does not list any OBIHAI devices in their BYOD section so I am out of luck. Can someone who processes PP calls OK cut and paste their dialing plan?
Taoman:
Quote from: PeteMoss on April 20, 2014, 03:36:41 pm
UPDATE: The PP site does not list any OBIHAI devices in their BYOD section so I am out of luck. Can someone who processes PP calls OK cut and paste their dialing plan?
I also used the Obi/PP setup wizard and have not experienced any problem. Here is the dialing plan that was put in place by the PP setup wizard:
(*xx|1xxxxxxxxxx|<1YYY>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*]@@.)
FWIW, I would recommend ending every dialing sequence with "#" every time you make a phone call.
If you want a simple DigitMap (not mine) that should work with PhonePower and decrease call setup time you can try this one:
([2-9]11S0|<1YYY>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|011xx.)
You would replace "YYY" with your local area code for 7-digit dialing.
Or you can use the first one which is pretty much the default Obi dialing plan. Either one should work. Gotta run....
PeteMoss:
I am using the simple one and it works fine so far. I will try yours if it develops issues. THANKS! And BTW, this is the dialing plan that I got with the PP/OBI prefigured provisioining:
(**|[3469]11|0|00|1xxxxxxxxxx|<1>[2-9]xxxxxxxxxS0|*21|*53xxxx|*6[27]xx.|*[789]2xx.|*73|*74[0-1][0-9]*xxxxxxxxxx|*75[0-1][0-9]|011xx.|xx.|(Mipd)|[^*#]@@.|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)
No wonder call setup took so long. The ATA had to do a lot of reading!! ;) ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page