Switched from GV to PhonePower - intermittent "not configured"
fugley4651:
I talked to a rep at PhonePower and he sent me this info. After I set this up according to the instructions, I did a FACTORY reset on the Obi100 and reinstalled the Obi100 plus the PhonePower . It's been over 36 hours and so far all is good. Incoming and outgoing calls are working fine. No having to keep resetting the Obi100. I'm keeping my fingers crossed. This link is for a Netgear router but the PhonePowers sight lists many others to work from. Hope this helps anyone. http://www.phonepower.com/wiki/NetGear_WNR2000v3
By the way, this has been working with the old firmware #2824, not the new firmware #2858.
CheapSk86:
If you guys could keep us updated with the latest given that some now have new firmware, and others seem to be receiving a positive response from PP, I, as I'm sure others, would appreciate the additional information.
I really like the look of the PP unlimited plan, especially given my monthly usage, but the service reliability has to be there for me.
Piggy backing on that, are any of you using the unlimited plan with them? And do you know if their unlimited plan is truly unlimited, or is it an advertising bait-and-switch like some of the others with maximum of 3000 or 4000 minutes?
Thanks again for all this info you guys are posting.
notconfident:
After countless hours trying to get this to Phone Power to work, I have given up. I simply don't have that much time to spend on it. I cancelled (now less than 24 hours after I signed up). Good luck to the rest of you!
KAura:
I am guessing that everybody has already tried this?
http://www.phonepower.com/wiki/Obihai_plans
fugley4651:
Just one more thing I realized that might have been causing the problem with PhonePower..The IP address of my router was DIFFERENT than what was being stored on the Obi100 by 1 number. It had it listed as 192.168.0.1. in the Obi100, whereas it should have been 192.168.1.1. I found this out by mistake by trying to log in on my web browser with the 192.168.0.1. number and it wouldn't connect to my Netgear router. After digging around on the web I found that my router was ACTUALLY the 192.168.1.1. number. After changing this on my router and in the Obi100, and doing what I posted earlier, I've had no problems with having to reset the Obi100 all the time. Just wanted to share this 1 more thing that might be causing people their problem with PhonePower.
Navigation
[0] Message Index
[#] Next page
[*] Previous page