InboundCallRoute timer for call forward?
obiliving:
Is it possible to show me a bit more how you configure this
so I too can give it a try?
I assume your
LINE Port InboundCallRoute = ph
LINE Port CallForwardOnNoAnswerEnable = yes (or checked)
LINE Port CallForwardOnNoAnswerRingCount = 5 (about 30s that is)
LINE Port CallForwardOnNoAnswerNumber = SP1(14081234567)
Assume your SP1 has a working ITSP or GV configured.
You can successfully dial out the same 11-digit number as your
call forward number from SP1 (using **1 prefix for example).
(otherwise try that first to make sure that the call forward number is indeed
valid from the SP1 point of view).
And the symptoms you are having:
- Incoming call from PSTN
- PHONE Rings
- PHONE keeps on ringing for more than 30s and the
call forward number is never called by OBi; never rings ...
totalimpact:
Sorry, got it working - you had a ; in your example, I thought that was required.
QBZappy:
obiliving,
I don't use the Line Port. However I'm trying to do the same thing with the SP1. I get "The number you are dialing is not in service" message. I think that is a dial pattern issue. I can't seem to find it. Can you suggest something?
totalimpact:
I got it to work just like Obiliving said:
LINE Port InboundCallRoute = ph
LINE Port CallForwardOnNoAnswerEnable = yes (or checked)
LINE Port CallForwardOnNoAnswerRingCount = 5 (about 30s that is)
LINE Port CallForwardOnNoAnswerNumber = SP1(14081234567)
Are you trying to do this from SP1 callers to a number on SP2? Pretty much all the same settings are available on an SP1or2 port that are on the Line port.
QBZappy:
My Obi is going through an Asterisk (FreePBX) box. I recognize the voice message is from Allison (Asterisk voice). I think it is an Asterisk config. I'm sure it that was not in the mix the Obi would handle the callforwarding.
Tks for the help.
Navigation
[0] Message Index
[*] Previous page