Problem With Callcentric Voicemail

<< < (2/4) > >>

GPz1100:
@RonR

Does your solution from April 30, 2011, 12:38:30 pm still work with current obi200/202 firmwares?

Adding just *123| to the itsp digit dialing map causes the obi to speed dial entry #3.

Both obi's have firmware 3.2.1 (Build: 5757EX).

I eventually did get it resolved but it involved the following.

Phone port digitmap
([1-9]x?*(Mpli)|[1-9]S9|[1-9][0-9]S9|911S0|933S0|*123S0|**0|***|#|##|**70(Mli)|**8(Mbt)|**81(Mbt)|**82(Mbt2)|**1(Msp1)|**2(Msp2)|**3(Msp3)|**4(Msp4)|**9(Mpp)|(Mpli))

Outboundcallroute (also under phone port)
{(911|933):sp3},{*123:sp3},{([1-9]x?*(Mpli)):pp},{(<##:>):li},{(<#:>):ph1},{(<**70:>(Mli)):li},{(<**82:>(Mbt2)):bt2},{(<**81:>(Mbt)):bt},{(<**8:>(Mbt)):bt},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**3:>(Msp3)):sp3},{(<**4:>(Msp4)):sp4},{(<**9:>(Mpp)):pp},{(Mpli):pli}

Using default ITSP (C) digit map (no changes here)
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)

*NOTE*  Removing *123S0 from the phone port digit map also causes it to speed dial entry #3.  Both have to be present for it to dial correctly.  I suppose as with most things obi related, there's 10 different ways to achieve the same/similar result. End goal is to just get callcentric voice mail when dialing *123.

Thanks

drgeoff:
@GPz1100

It is 6 years since RonR's last post on this forum.

Adding anything to an ITSP digit map will still not get it through the phone port digit map unless the phone port digit map references that ITSP digit map either directly or as the primary line.  Your phone port digit map had no call to the sp3 digit map except when the **3 prefix is dialled.

GPz1100:
Doh! Thanks for pointing that out :).   I'll contact him elsewhere.

As for the issue/solution, I couldn't find any more recent posts about this so assumed the solution was still working.  After much trial/error, came up with what I posted above.

drgeoff:
See the addition to my edited post.

GPz1100:
Quote from: drgeoff on April 13, 2018, 03:00:42 pm


Adding anything to an ITSP digit map will still not get it through the phone port digit map unless the phone port digit map references that ITSP digit map either directly or as the primary line.  Your phone port digit map had no call to the sp3 digit map.


Got it.  The additions above do work but is there a more preferred way of implementing this?  My digitmap logic is failing today.

Navigation

[0] Message Index

[#] Next page

[*] Previous page