SP1 Connected but not Registered
tazdevil:
I am doing this for my friends.
Because GV+OBi100 will stop working mid May I am trying to use OBi100 as a regular VoIP ATA.
Deleted GV from SP1. Signed up a CallCentric account and tried to set up SP1 with it. The status of SP1 shows "Connected" instead of "Registered". CallCentric dashboard does not show registration.
My goal is to register SP1 with SipSorcery and then use GV+CallCentric+SipSorcery <=> OBi100 to make US domestic calls.
SP2 is properly registered with Voip.ms
BTW, I have done GV+CallCentric+SipSorcery <=> OBi100 on SP1 before and all are fine. That device has only SP1 registered with SipSorcery. SP2 was left blank.
N7AS:
Remember when going from GV to a SIP account to check...
Service Providers > ITSP Profile A > General >
SignalingProtocol: SIP
You may have GoogleVoice selected.
tazdevil:
I do everything through OBiTALK:
Delete SP1 setting (GV) and then configure new SP1 (SIP). Do I have to enter into "expert mode", I am no expert.
I've configered another OBi100 that way and there is no such issue.
N7AS:
Yes you will have to enter Expert Configuration. I don't configure my devices on the OBiTalk portal but directly on the device. If I can remember correctly, when changing settings you have to uncheck both boxes to the right of the value you are changing. Then save the settings. The device will rebot after a short time.
tazdevil:
Thanks for the reply.
The signaling protocal does not seem to be the issue.
I do all the configuration remotely through OBiTalk. I am helping a friend remotely.
I can see the detailed settings through Expert mode and I can see the correct SIP signaling protocol
Service Providers > ITSP Profile A > General >
SignalingProtocol: SIP
Maybe we need a reboot? Will the device reboot by itself when I change SP1 remotely? Or do I have to ask my friend to reboot physically?
Navigation
[0] Message Index
[#] Next page