OBi202 OBiTalk Portal Firmware Check?
gderf:
If you don't see a Firmware Update notice in your OBiTALK OBi dashboard, then your firmware is current or perhaps you have that feature disabled and you don't get those notices.
Under Status/System Status in the Expert Configuration menu, it should show under Product Information:
ModelName
MACAddress
SerialNumber
OBiNumber
HardwareVersion
SoftwareVersion
and some more.
No idea why putting the device's bare IP address into the browser address bar is failing. For me it pops up the login box. Maybe try http://ip-address
giqcass:
Depending on the setup of your Obi202 on the network you may need to enable access. If you plug in to the obi as a router this need not be done. If everything is plugge in to a separate router the Obi will consider the request as if it came from WAN. No point rewriting the post so I'll just quote QBZappy on the same topic.
Quote from: QBZappy on November 16, 2012, 07:55:44 pm
FAQ: http://www.obihai.com/FAQ.html
How do I enable access to OBi202 Internal Web Admin Configuration UI via the WAN IP?
By default, web access to the Internet (WAN) IP address of the OBi202 is disabled. Accessing the Internet (WAN) IP will show, "The requested URL was not found!" or "The webpage cannot be found" in your browser. Note: You may always access the webpage from the LAN side of the OBi202, e.g. connect your PC to the LAN port of the OBi202. To enable access to the OBi202
- Dial ***0 from the phone connected to the OBi202
- Enter 30#
- Press 1 to Enter a New Value
- Press 1# to Enable
- Press 1 to Save
To disable Internet (WAN) port access do the following:
- Dial ***0 from the phone connected to the OBi202
- Enter 30#
- Press 1 to Enter a New Value
- Press 0# to Disable
- Press 1 to Save
BruceB:
gderf -- I expect that you are right, no firmware update is needed. Either that, or OBiTalk doesn't have my firmware version so doesn't know whether or not an update is needed, for the same reason that the Status/System Status doesn't display the last 2 fields (HardwareVersion and SoftwareVersion). I clicked on the (E) icon to get "Advanced Configuration", then System Status under Status, and only get the first 4 fields. Is there a different way to get there?
giqcass -- My OBi202 has an OBiWiFi plugged into it, which communicates via WiFi to my AT&T-supplied 2Wire router. So the OBi202 is not acting as a router. I don't see why the OBi would then think that my LAN is a WAN, but that did the trick, enabling me to connect to the OBi202 from a browser.
Does this cause my OBi202 to become vulnerable to network attacks from outside (i.e. real WAN)? Is such an attack on the OBi likely? If so, that means I should leave it enabled for as short a time as possible.
gderf:
I have an OBi200, not a 202, so there are bound to be some differences in what is displayed. But they both run the same firmware so I don't know why you shouldn't be seeing that kind of basic information.
BruceB:
The firmware version did show up in the local configuration page, once I was able to access it, and I have the latest version. Though the firmware update exercise was somewhat a waste, I'm happy that I can now get to the local configuration page!
Thanks for your help.
Navigation
[0] Message Index
[#] Next page
[*] Previous page